The Motobilt Jeep JK Rear Frame Chop Bumper allows for 5 inches of additional ground clearance over the factory receiver hitch. The additional ground clearance you gain is the same as going from a 35 inch tire to a 40 inch.
- material: Steel
Motobilt
Motobilt Jeep JK Frame Chop Rear Bumper and Cross Member
0
(No reviews yet)
Write a Review
Write a Review
Motobilt
Motobilt Jeep JK Frame Chop Rear Bumper and Cross Member
$696.08
- SKU:
- M05M MB1081
Related Products
An relatable roduct
Check out the Motobilt Jeep JK Rear Stubby Bumper. The Motobilt Jeep JK Rear Stubby Bumper was built to be compact and strong. The bumper body is constructed with 3/16 inch high strength steel plate...
$579.88
The Motobilt rear Jeep TJ (1997-2006) cross member is the strongest available. We base this claim because we did not simply use thicker material we also added gusseting to the cross member. The...
$263.00
Frame Chop Front Bumpers are nothing new to the offroad community. Here at Motobilt we wanted to raise the bar a little. The Tomahawk front bumper was designed from concepts developed on the TJ Front...
$843.95
The new Motobilt Jeep JK rear aluminum fenders will clean up your Jeep. When you remove the rear plastic inner liner of your Jeep JK you will see your left with large open voids that will pack full...
$263.00
The Motobilt Jeep Wrangler JK Crusher recessed winch bumper will provide you the ultimate in protection and recovery. The bumper allows you to secure your winch down low in between the frame rails...
$696.08